Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

ULTRAJET AND ULTRAJET ALL-WAY #329-2684

NFPA

PRODUCT USE

The use of a quantity of material in an unventilated or confined space may result in
increased exposure and an irritating atmosphere developing.Before starting consider
control of exposure by mechanical ventilation. Application is by spray atomization from a
hand held aerosol pack. Cleaning products.

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

Forms very sensitive explosive metallic compounds.
Risk of explosion if heated under confinement.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Overexposure is unlikely in this form.  Not normally a hazard due to physical form of product.  Considered an unlikely route of entry in commercial/industrial environments.  

EYE

  Although the material is not thought to be an irritant, direct contact with the eye may produce transient discomfort characterized by tearing or conjunctival redness (as with windburn).  Not considered to be a risk because of the extreme volatility of the gas.  

SKIN

  Skin contact is not thought to have harmful health effects, however the material may still produce health damage following entry through wounds, lesions or abrasions.  There is some evidence to suggest that this material can cause inflammation of the skin on contact in some persons.  Spray mist may produce discomfort.  Fluorocarbons remove natural oils from the skin, causing irritation,dryness and sensitivity.  Entry into the blood-stream, through, for example, cuts, abrasions or lesions, may produce systemic injury with harmful effects. Examine the skin prior to the use of the material and ensure that any external damage is suitably protected.  

INHALED

  There is some evidence to suggest that this material, if inhaled, can irritate the throat and lungs of some persons.  Inhalation of vapours may cause drowsiness and dizziness. This may be accompanied by narcosis, reduced alertness, loss of reflexes, lack of coordination and vertigo.  Inhalation of aerosols (mists, fumes), generated by the material during the course of normal handling, may be damaging to the health of the individual.  Material is highly volatile and may quickly form a concentrated atmosphere in confined or unventilated areas. Vapor is heavier than air and may displace and replace air in breathing zone, acting as a simple asphyxiant. This may happen with little warning of overexposure.  The use of a quantity of material in an unventilated or confined space may result in increased exposure and an irritating atmosphere developing.Before starting consider control of exposure by mechanical ventilation.  WARNING: Intentional misuse by concentrating/inhaling contents may be lethal.  Exposure to fluorocarbons can produce non-specific flu-like symptoms such as chills, fever, weakness, muscle pain, headache, chest discomfort, sore throat and dry cough with rapid recovery. High concentrations can cause irregular heartbeats and a stepwise reduction in lung capacity. Heart rate may be reduced.  Acute intoxication by halogenated aliphatic hydrocarbons appears to take place over two stages. Signs of a reversible narcosis are evident in the first stage and in the second stage signs of injury to organs may become evident, a single organ alone is (almost) never involved.  

CHRONIC HEALTH EFFECTS

  Limited evidence suggests that repeated or long-term occupational exposure may produce cumulative health effects involving organs or biochemical systems.  Principal route of occupational exposure to the gas is by inhalation.  Fluorocarbons can cause an increased risk of cancer, spontaneous abortionand birth defects.  Chronic exposure to alkyl ethers may result in loss of appetite, excessivethirst, fatigue,  and weight loss.