Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

WATTYL DIMET ROAD MARKING PAINT 1366 WHITE - SOLVENT BASE

NFPA

PRODUCT USE

The use of a quantity of material in an unventilated or confined space may result in
increased exposure and an irritating atmosphere developing.Before starting consider
control of exposure by mechanical ventilation. Spraying of road markings is normal in
completely open atmospheres however the potential for operator exposure may be high
considering the large volumes of material atomized, the position of operator following a
leading boom and the continuous nature of the operation in highway marking. Particular
attention should be given to spraying in basement car parks or other enclosed areas. If
inhalation risk exists, wear SAA approved organic- vapor respirator. In conditions where
worker exposure is very high, wear full face air supplied breathing apparatus. Provide
adequate ventilation in warehouse or closed storage areas. A very rapid drying paint that
is usually applied by spray atomisation to roadways, airport runways for traffic marking.

SYNONYMS

"White Pavement Line Marking Paint", "road marking lacquer"

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

Harmful if swallowed.
Possible risk of harm to the unborn child.
HARMFUL - May cause lung damage if swallowed.
Harmful: danger of serious damage to health by prolonged exposure through
inhalation.
Irritating to eyes and skin.
Highly flammable.
Vapors may cause dizziness or suffocation.
Dangerous for the ozone layer.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Accidental ingestion of the material may be harmful; animal experiments indicate that ingestion of less than 150 gram may be fatal or may produce serious damage to the health of the individual.  Not a likely route of entry into the body in commercial or industrial environments. The liquid may produce considerable gastrointestinal discomfort and be harmful or toxic if swallowed. Ingestion may cause nausea, pain and vomiting. Vomit entering the lungs by aspiration can cause inflammation of the lungs, which can lead to death.  

EYE

  This material can cause eye irritation and damage in some persons.  The material may produce severe irritation to the eye causing pronounced inflammation. Repeated or prolonged exposure to irritants may produce conjunctivitis.  

SKIN

  This material can cause inflammation of the skin oncontact in some persons.  Skin contact is not thought to have harmful health effects, however the material may still produce health damage following entry through wounds, lesions or abrasions.  Toxic effects may result from skin absorption.  The material may cause skin irritation after prolonged or repeated exposure and may produce on contact skin redness, swelling, the production of vesicles, scaling and thickening of the skin.  

INHALED

  Inhalation may produce health damage*.  The material is not thought to produce respiratory irritation (as classified using animal models). Nevertheless inhalation of the material, especially for prolonged periods, may produce respiratory discomfort and occasionally, distress.  Inhalation hazard is increased at higher temperatures.  Inhalation of high concentrations of gas/vapor causes lung irritation with coughing and nausea, central nervous depression with headache and dizziness, slowing of reflexes, fatigue and inco-ordination.  If exposure to highly concentrated solvent atmosphere is prolonged this may lead to narcosis, unconsciousness, even coma and possible death.  

CHRONIC HEALTH EFFECTS

  Principal routes of exposure are usually by inhalation of vapor/spray mist and skin contact with the material.  Prolonged or continuous skin contact with the liquid may cause defatting with drying, cracking, irritation and dermatitis following.  Chronic solvent inhalation exposures may result in nervous system impairment and liver and blood changes. [PATTYS].