QUIKCOTE RG-1000
Flammability | 0 | |
Toxicity | 0 | |
Body Contact | 3 | |
Reactivity | 0 | |
Chronic | 2 | |
SCALE: Min/Nil=0 Low=1 Moderate=2 High=3 Extreme=4 |
Mixed with water and used to plaster walls and concrete ceilings, masonry etc.
plaster, "Quickcoat (misspelling)"
Causes burns.
Risk of serious damage to eyes.
The material can produce chemical burns within the oral cavity and gastrointestinal tract following ingestion. Considered an unlikely route of entry in commercial/industrial environments. Not normally a hazard due to the physical form of product. The material is a physical irritant to the gastrointestinal tract. Ingestion may result in nausea, abdominal irritation, pain and vomiting.
The material can produce chemical burns to the eye following direct contact. Vapors or mists may be extremely irritating. If applied to the eyes, this material causes severe eye damage. The material may produce severe irritation to the eye causing pronounced inflammation. Repeated or prolonged exposure to irritants may produce conjunctivitis.
The material can produce chemical burns following direct contactwith the skin. Products when wet may be quite alkaline and this alkali action on the skin may contribute to cement contact dermatitis by causing drying and defatting of the skin which may be followed by hardening, cracking, development of lesions, possible infections of lesions and penetration by soluble salts. The material may accentuate any pre-existing dermatitis condition. Cement contact dermatitis (CCD) may occur when contact shows an allergic response, which may progress to sensitization. Sensitization is due to soluble chromates (chromate compounds) present in trace amounts in some cements, cement products. Soluble chromates readily penetrate intact skin. Cement dermatitis can be characterized by fissures, eczematous rash, dystrophic nails, and dry skin; acute contact with highly alkaline mixtures may cause localized necrosis. The material may cause skin irritation after prolonged or repeated exposure and may produce on contact skin redness, swelling, the production of vesicles, scaling and thickening of the skin.
If inhaled, this material can irritate the throat andlungs of some persons. Inhalation of dust may aggravate a pre-existing respiratory condition such as asthma, bronchitis, emphysema.
There is some evidence that inhaling this product is more likely to cause a sensitization reaction in some persons compared to the general population.
Principal routes of exposure are by accidental skin and eye contact andinhalation of generated dusts. Prolonged or repeated skin contact may cause drying with cracking,irritation and possible dermatitis following. As with any chemical product, contact with unprotected bare skin; inhalation of vapor, mist or dust in work place atmosphere; or ingestion in any form, should be avoided by observing good occupational work practice. Long term exposure to high dust concentrations may cause changes in lung function i.e. pneumoconiosis; caused by particles less than 0.5 micron penetrating and remaining in the lung. Prime symptom is breathlessness; lung shadows show on X-ray. One ingredient of the product has caused skin sensitization reactions, shown as localized reddening and hives, or may produce respiratory sensitization characterized by asthma- like symptoms and runny nose. Cement eczema may be due to chromium in feed stocks or contamination from materials of construction. Sensitisation to chromium may be the leading cause of nickel and cobalt sensitivity and the high alkalinity of cement is an important factor in cement dermatoses [ILO].